歡迎您光臨本站 登入註冊首頁

OrCAD Power PIN 的注意事?

admin @ 2014-03-26 , reply:0

概述

   在OrCADCapture建part時,其pin的特性會影響後續在線路圖的接線及轉出的連線關係。   Part的接點基本上可分一般訊號……

    在 OrCAD Capture 建part時,其pin 的特性會影響後續在線路圖的接線及轉出的連線關係。
    Part 的接點基本上可分 一般訊號PIN電源訊號PIN
    在使用時請特別注意其特性及差異。

  • 一般訊號 PIN
        指 Type 為 POWER 以外的一般訊號.需要接上 wire或port等才會有連線關係,或可用Place/No Connect宣告不接。
        在同一顆 Part 中其 Pin name 必須是唯一且不可重複的.如 IDE0,IDE1……
     .
        * Pin name 與 Pin number 不能是空白
  • 電源訊號 PIN
        指Type 為 POWER 之電源訊號 .
        此種 PIN 其特點是同顆part內 PIN NAME 可重複,訊號名稱net name會以其 PIN NAME 為內定名稱,但以其用法又可分為 顯示 Visible On不顯示Visible Off

        Type Power-Visible On 
        訊號名稱net name會以其 PIN NAME 為內定名稱,但其訊號名稱會依所接的wire或port訊號而更改
     
        只有 Pin Type 是 Power 時才可以在同顆part內用多個相同的 Pin name。
    以下為引用的內容:
    A power pin is by default connected to a global net that has the same name as the power pin. You can override this default connection by making the power pin visible and connect it to a wire or other electrical object to change its connection to the default net name.You cannot have duplicate pin names for any other pin type except for power pins.

         Type Power-Visible Off 
        訊號名稱net name會以其 PIN NAME 為內定名稱,可用來定義 Part 中的    內定電源隱藏 Pin,尤其指不會更改訊號名稱的內定電源 pin。
     
        ##############(以下設定只有在Cadence-Allegro新轉法有效) ################
        但如果內定電源 pin有以下狀況:
        ◆不須做訊號轉接時 Pin name = Net name
        如 Pin name 為 Gnd 所接出來的 Net name -> Gnd
        不須做任何宣告

        ◆須做訊號轉接時 Pin name ≠Net name
        如 Pin name 為 VDD 但需要轉接到 VCC訊號, 且 VSS 也需要轉接到VCC訊號 此時就必須 對 Part 做設定,
        各宣告設定間以 ?作區隔才可設入多組.
        針對 Part – Edit Properties attribute keyword 為 POWER_GROUP
     
        * 如果是複合式的零件需注意所有的 Property 要一致

[admin via 研發互助社區 ] OrCAD Power PIN 的注意事?已經有32729次圍觀

http://cocdig.com/docs/show-post-44193.html